Chaotica Fractals Forum
https://www.chaoticafractals.com/forum/

bezier curves...
https://www.chaoticafractals.com/forum/viewtopic.php?f=7&t=3056
Page 1 of 1

Author:  DoctorChaos [ Thu Jun 20, 2019 5:23 pm ]
Post subject:  bezier curves...

Is there any way to *not* use bezier curves during animation sequences?
Often I'm just wanting a linear value change. Bezier curves often give me wild results with values flying off the scale until returning back to something I want.

Attachments:
bez.jpg
bez.jpg [ 129.18 KiB | Viewed 31533 times ]

Author:  DoctorChaos [ Thu Jun 20, 2019 8:29 pm ]
Post subject:  Re: bezier curves...

I wanted to post this...but the graphic was too large....so here it is on imgur instead :)

Image

(I couldn't find a way to edit my initial post)

Author:  DoctorChaos [ Sun Jul 07, 2019 9:38 pm ]
Post subject:  Re: bezier curves...

Image

Author:  DoctorChaos [ Thu Jul 18, 2019 10:38 am ]
Post subject:  Re: bezier curves...

Image
Image

Author:  DoctorChaos [ Wed Jul 31, 2019 1:51 am ]
Post subject:  Re: bezier curves...

tap, tap, tap...is this thing on?

Attachments:
for-me-it-has-been-painful.gif
for-me-it-has-been-painful.gif [ 570.79 KiB | Viewed 31293 times ]
giphy.gif
giphy.gif [ 483.66 KiB | Viewed 31293 times ]

Author:  Nick [ Wed Aug 21, 2019 2:49 pm ]
Post subject:  Re: bezier curves...

Hi, nice gif collection :)
There is no way to just use linear currently, sorry.

Author:  DoctorChaos [ Fri Aug 30, 2019 12:15 pm ]
Post subject:  Re: bezier curves...

Hopefully you'd consider another method as this creates crazily unpredictable and unwanted results at times.

Author:  Nick [ Thu Nov 28, 2019 6:00 am ]
Post subject:  Re: bezier curves...

Here you go: https://www.chaoticafractals.com/node/1 ... f=2&t=3163

Author:  Jackeroni [ Wed Dec 04, 2019 10:41 pm ]
Post subject:  Re: bezier curves...

Sorry if this isn't what you were looking for but, you could also place a node at either side of the part of the curve that you wish to edit so that anything beyond them won't be touched.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/